300blk question

[Wes Sage]

Probably from an extractor if it is a burr on the rim of any sort.
I have never had 1 piece of our 300blk brass not fit in a gun out there, so if it is right from us, load and go
Even the small burr won't normally effect anything.
Body buldge at the bottom will still be smaller than SAAMI Spec and will fit in your gun

These are from you Wes. You use a small base die correct? It seems where the case head is there is a burr and slightly out of round. Probably from the extractor.

Sent from my SM-N910V using Tapatalk

[Guns4545]

Probably from an extractor if it is a burr on the rim of any sort.
I have never had 1 piece of our 300blk brass not fit in a gun out there, so if it is right from us, load and go
Even the small burr won't normally effect anything.
Body buldge at the bottom will still be smaller than SAAMI Spec and will fit in your gun

Perfect. Never had any issues yet with any of your brass. I was just wondering. Still learning. Thanks for the help as always buddy [emoji106][emoji106][emoji106]

Sent from my SM-N910V using Tapatalk

[Wes Sage]

Anytime buddy!!
Thanks for being here on the forum, and using it

Perfect. Never had any issues yet with any of your brass. I was just wondering. Still learning. Thanks for the help as always buddy [emoji106][emoji106][emoji106]

Sent from my SM-N910V using Tapatalk