Today at the Bench.....

[Flyeralan]

Here is a small sampling of some items I've printed. In addition, an air draft block for my Charge Master, my cam wire breakaway brackets for my LnL, powder identifying bands to clip on the powder drops, and a multitude of other items. The second picture is the very beginning of the Hornady component separating top for the measure. It will fit on top of the powder drop and I can dump my bullet pulling hammer right into it, the powder will go into the hopper, and I can pick the bullet out very easily. Assuming everything prints and works as I plan, lol.
Printed items.jpg
Hornady separator top.jpg

[JeffreyDeGraff]

Here is a small sampling of some items I've printed. In addition, an air draft block for my Charge Master, my cam wire breakaway brackets for my LnL, powder identifying bands to clip on the powder drops, and a multitude of other items. The second picture is the very beginning of the Hornady component separating top for the measure. It will fit on top of the powder drop and I can dump my bullet pulling hammer right into it, the powder will go into the hopper, and I can pick the bullet out very easily. Assuming everything prints and works as I plan, lol.
Printed items.jpg
Hornady separator top.jpg

Very cool stuff. I love the idea of that separator, definitely would make life easier when pulling bullets. Can’t wait to see the finished product.

One day, if I ever get around to getting a 3D printer for myself, I may send you a private message, to pick your brain a little.


JTD