Do you have any of the brass that is not loaded? Try chambering a sized brass and see if it goes into battery. I have had to bump the shoulder back a few thousands at a time until the the bolt would go into full battery. Then start seating the bullets and testing for full battery.
Currently reloading for .380 ACP, 9MM,327 Federal Mag, 38 Special, .357 Mag, 40 S&W, 44 Mag, 45 ACP, .458 Socom, .223 Remington, 22-250,7MM Remington Mag, 30-06 and 340 Weatherby Mag, 50 Beowolf
Yes, I've tried chambering only brass, it all works just fine.Originally Posted by Adam Van Camp
I went one step further and did a plunk test with a live round separated from the lower, it plunks and falls out perfect. I'm starting to think that this is not a seating depth issue at all, rather it is something with the bolt carrier or feed ramps and how they interlock.
Posting Permissions
Reply With Quote