Giraud tri-way

[Kbeaton]

Just got done doing about 1k cases. This thing is great! Couple problems that came up. These are most likely attributable to my inexperience with this tool.
- I had to stop a few times to clean brass clippings out from the area where it indexes off the cases. This is a bit concerning as some may have slipped by with incorrect cuts.
- there were a few times that if I jammed it in to fast the blades would grab the case and spin it in my fingers
- what’s the best way to empty this thing?
Please chime in if you have any tips.


Sent from my iPhone using Tapatalk

[CodySPowell]

Just got done doing about 1k cases. This thing is great! Couple problems that came up. These are most likely attributable to my inexperience with this tool.
- I had to stop a few times to clean brass clippings out from the area where it indexes off the cases. This is a bit concerning as some may have slipped by with incorrect cuts.
- there were a few times that if I jammed it in to fast the blades would grab the case and spin it in my fingers
- what’s the best way to empty this thing?
Please chime in if you have any tips.


Sent from my iPhone using Tapatalk

I use a Qtip to clean the area where the brass indexes as I trim. I bought some cheap paint brushes to clean the cutter when I'm done.

Sent from my SM-J727V using Tapatalk