Lead splice cases

[2wheelDuke]

When I melt stuff like that down I use a cutting torch outside. At 2000 degrees you'll burn off all the trash pretty easy. Where respirator if it

Sent from my SM-G965U1 using Tapatalk

I don't recommend that at all. You want to keep the temperature below lead's boiling point.

The gunk will typically burn off. I use a propane torch to light the smoke up when I'm smelting. It doesn't smoke nearly as bad when it's on fire.

Sent from my SM-G930V using Tapatalk

[Kbeaton]

I don't recommend that at all. You want to keep the temperature below lead's boiling point.

The gunk will typically burn off. I use a propane torch to light the smoke up when I'm smelting. It doesn't smoke nearly as bad when it's on fire.

Sent from my SM-G930V using Tapatalk

Yeah I’m not sure about the torch method. It’s a petroleum product. You think that would smoke off? It cleans up with gasoline when you get it on your hands. I just don’t want to ruin all this lead.


Sent from my iPhone using Tapatalk

[Shane P]

I don't recommend that at all. You want to keep the temperature below lead's boiling point.

The gunk will typically burn off. I use a propane torch to light the smoke up when I'm smelting. It doesn't smoke nearly as bad when it's on fire.

Sent from my SM-G930V using Tapatalk

My bullets turn out great. Ben doing it for years. Everybody has a technique. That's just my first melt and it's in a strainer so it reaches temp and into the first mold it goes.

Sent from my SM-G965U1 using Tapatalk

[Kbeaton]

My bullets turn out great. Ben doing it for years. Everybody has a technique. That's just my first melt and it's in a strainer so it reaches temp and into the first mold it goes.

Sent from my SM-G965U1 using Tapatalk

Those do look good but did they come from a splice case?


Sent from my iPhone using Tapatalk

[Shane P]

Those do look good but did they come from a splice case?


Sent from my iPhone using Tapatalk

No sir wheel weight

Sent from my SM-G965U1 using Tapatalk