In What order does everyone prep their brass for shooting out to 1000 yards? And what equipment do you use for each step? I have been doing the following steps for my 223 brass. This is after removing any crimps and deburring the flash holes on the inside. I am not loading huge quantities and use a Lee Classic Cast press.

1. Decap with Lee or Mighty Armory Decapping Die in a Lee Hand Press
2. Wet tumble with SS chips, Dawn & Lemishine. Dry and inspect brass.
3. Resize using Forester SB Body Die Bump Shoulders .004
4. Resize neck and set neck tension to .002 with Lee Collet Die
5. Trim to length with Lee Trimmer I want to upgrade my trimmer ASAP
6. Chamfer and deburr neck with Lyman tools. ELD inside chamfer.
7. Wet tumble too remove case lube. No SS chips just Dawn.
8. Prime cases using Lee hand primer.
9. Charge cases with powder. Right now I am dipping and trickling each charge on an Ohaus beam scale.
10. Seat bullets to ogive length with Forester Micrometer Seating Die

I think that pretty much covers it. I have not gotten in to sorting cases by volume or bullets by weight or ogive length yet. Maybe in the future I will go down that rabbit hole. So what do you guys do?