Loaded up some 62gr tracers with H335
Started at 22.0gns and worked up in .5 increments to 23.5gns. Hope to test these soon and I'll post my results.
CCI #41 primers
LC brass
OAL 2.260
Sent from my SM-J727V using Tapatalk
I will be honest, I found that 23.5 Grain of H335 seemed to be the magic number for me. If i load them up to about 25 they turn into flares.
Looking forward to your results!
Anyone using a crimp with these? haven't loaded them yet just gathering info.
I didn't, I could feel that there was plenty of neck tension due to the length of the projectile.
Sent from my SM-J727V using Tapatalk
I put a light crimp to them just to make sure there was no setback when running through my AR
Neck tension should hold it on most rifles, but on an AR type think I would put a crimp on it as you stated.