RCBS Jr3 Primer Catcher

[Steve Lonie]

I have an old RCBS Jr3 press that I'll use for bullet and case sizing along with decapping brass before I clean and tumble. I see RCBS has a catcher tray and there are a few folks who 3D print catchers also. I'm looking for thoughts and opinions on which ones work the best.

[Sublime1]

Look up loadertools.com Chris makes the best there is.

Sent from my LM-Q710(FGN) using Tapatalk

[Steve Lonie]

Look up loadertools.com Chris makes the best there is.

Yep, I saw his. It requires rotating the ram 180 degrees though. Not a deal breaker it just means priming on the press will be a problem if I decide to later on.

[Shane P]

I have an old RCBS Jr3 press that I'll use for bullet and case sizing along with decapping brass before I clean and tumble. I see RCBS has a catcher tray and there are a few folks who 3D print catchers also. I'm looking for thoughts and opinions on which ones work the best.

Chris does a good job, I called rcbs and they sent me a free one. But chris will have an upgraded one

Sent from my SM-G965U1 using Tapatalk