300 blackout and Lee resizing dies neck tension.

[Guns4545]

So here is a way to measure the neck tension on your bullets. After you size your brass with your lee die, measure the outside diameter of the case neck. Then after you seat your bullet, measure the outside diameter of the neck again. The difference of those two numbers would give you an idea of how much neck tension there is. If it grows by at least .002”, that should be enough neck tension.


Sent from my iPhone using Tapatalk

No I measured before. I check ID of the case neck after resized.

Sent from my SM-N910V using Tapatalk

[JeffreyDeGraff]

Ok. But if you measure the outsides necks before and after seating, it will let you know if there is enough tension.


Sent from my iPhone using Tapatalk

[Guns4545]

I'll do that. Thanks for the help

Ok. But if you measure the outsides necks before and after seating, it will let you know if there is enough tension.


Sent from my iPhone using Tapatalk

Sent from my SM-N910V using Tapatalk