Uhhhhhh......??? (6.5 creed)

[logan.engle]

Take the decapping pins out and insert in a drill and run them through sand paper to make them smaller. That's what I did with the set I had. Also, run your brass through the neck size die to set the neck tension. If the seating die is leaving a ring like that, it's because the neck tension is too high.

Awesome! I’ll try that with the pins!

I actually just tried that and the ring became very much less prominent but it’s still their. Lee said they make a custom bullet seating plug so hopefully that’ll help to eliminate the ring. Thanks for the help!


Sent from my iPhone using Tapatalk

[SouthernCoyote]

Awesome! I’ll try that with the pins!

I actually just tried that and the ring became very much less prominent but it’s still their. Lee said they make a custom bullet seating plug so hopefully that’ll help to eliminate the ring. Thanks for the help!


Sent from my iPhone using Tapatalk

Also clean the annealing residue off, it will remove the extra friction. A 30 minute tumble will get it off. I also dip my bullets base in dry neck sizing lube (graphite) to make seating way smoother.