Ammo compatibility question

[Mambochicken]

Question for the group. I put a new barrel on my hunting rifle this year, and was planning to shoot 150 gr Barnes TTSX hand loads. But I just ran out of time to do load development.

I have a full box of 178 gr Hornady eld-x ammo that I can use. But I’m not sure if it’s a good fit with the new barrel.

I’m shooting a 30-06, and went with an 18” length with a 1:10 twist for the lighter bullets. Will it work with the heavier bullets? If it’s relevant, I’ll be shooting it suppressed.

Any help and insight is greatly appreciated.


Sent from my iPhone using Tapatalk

[Harter]

The 1-10" 30 cal will stabilize almost every bullet under 1.2 inches in length . Copper Monolith bullets up to 190 gr should be ok 210 gr cup and core spire points and 220 spritzers used to be the heavyweight moose slayers in 06' .

[Mambochicken]

Excellent, so the 178’s I have should be fine. Perfect, that saves me the cost of another box of ammo then.

Much appreciated.


Sent from my iPhone using Tapatalk