Opinion needed on my 3D printed bullet feeder

[Lunatic728]

So I can't afford to buy or justify the cost of a motorized bullet feeding system. So I have looked around and didn't find anything I really liked. So I designed and printed my own bullet feeder (just for Hornady dies). My son says I should sell it but I really don't know if it is worth my time.

This is ONLY for the HORNADY BULLET FEEDER DIE's (9MM, 40cal, 45ACP, 44MAG) It holds 150+ of 9MM. It fits snugly on the die and a set screw holds is just for added security. It has 6 polycarbonate tubes that rotate. I also designed a 6 spot funnel to help in loading the bullets into the tubes. It takes me about 5 min. to fill all 6 tubes.

So there it is I would like a different opinion on this. For the time I spend printing it and the cost of tubes I would have to get 50.00 each plus shipping just to make a little bit. Below are the pictures.

Tell me I am crazy or I am a genius either way I am ok with.

Bullet feeder - 1.jpgBullet feeder - 3.jpgBullet Feeder - 2.jpg

[Solomon.trenton]

Including tubes? What length are they?

Sent from my SM-G973U using Tapatalk

[Lunatic728]

Including tubes? What length are they?

Sent from my SM-G973U using Tapatalk

Yes including tubes. It is 18" tall from the base to the top of the funnel.

[Solomon.trenton]

Yes including tubes. It is 18" tall from the base to the top of the funnel.

I think that is close to a few others i have seen

Sent from my SM-G973U using Tapatalk

[Andyt2]

Looks great - I do not have the Hornaday die but it probably would not be hard to make it fit other dies with just an adapter. $50 is cheap Think you could get $more for it. Just my 3 cents

[Solomon.trenton]

Yes including tubes. It is 18" tall from the base to the top of the funnel.

https://www.doublealpha.biz/us/mini-...etfeeder-tubes

They have one for $50, but appears this is only for their die

Sent from my SM-G973U using Tapatalk