Just finished building my die and book shelf. Now I need to fill it up.
Sent from my SM-N950U using Tapatalk
It’s a modest start...
Carved out a 5’ wall section in the storage room so I could build a proper bench/space. Have been mucking around with a D550 mounted to a butcher block top clamped to a 1980s era workmate with components stored hear n there around my office.
Lighting and electric done.
Also sheathing the under stair 4’ square space and building shelves to consolidate component storage and finished freedom seeds.
ETA - finished the shelves yesterday. Managed to get 3 in the space available and have the current components all in one place for the first time. These carry a lot of weight so I lagged a 2x4 cleat into the studs and then built a 2x4 frame. The frame has additional cross pieces for strength and then was clad in 3/4” MDF. I may add some 2x4 ‘jacks’ between the shelves so that the load is carried all the way to the floor
Lots of great ideas for workspace layout and organization in this thread. Thx for posting pix.
Sent from my iPhone using Tapatalk
Last edited by Shamr0ck; 06-05-2019 at 07:01 AM.
Took this...
And turned it into this....
Using the inline fabrications quick change plate and will mount my D550 and Yost 445 as needed
Now all I need to do is man handle it into the corner and lag it to the wall
Sent from my iPhone using Tapatalk
Updated my reloading room after our move. I have the largest of the spare bedrooms all to myself.
Tumblers have been moved to a station out on the back screened in porch, so I can work in relative peace inside.