Today at the Bench.....

[Flyeralan]

Here is the finished product, turned out a little too large to fit in my Hornady tubes and had to sand them a little. If I make them again I will just scale them to 98 or 99% and it should work great.
Hornady drop.png
Hornady drop.1.png

[JeffreyDeGraff]

Here is the finished product, turned out a little too large to fit in my Hornady tubes and had to sand them a little. If I make them again I will just scale them to 98 or 99% and it should work great.
Hornady drop.png
Hornady drop.1.png

Looks great. Perfect for just pouring powder to refill, and for separating powder from bullet after pulling.

When you were first talking about it, I envisioned something you would put on and take off as needed. Now I see that it is the permanent new cap. Very nice.


JTD