Finally getting back to reloading a bit. Spent a couple hours last night over a zoom call with my cousin, who’s starting to reload, on going over the steps of setting up a sizing die and going over the steps of trimming/deburring/chamfering. He’s read the ABC’s of Reloading and I think just got overwhelmed a bit. Since I have to reset all my dies since the addition of a wear plate to my co-ax, I figured it’d be helpful for him to see the process. It worked well too as I had my rifle handy to show the process of adjusting to your rifles chamber rather than just following the directions that come with the dies. All in all, I resized 5 pieces of brass for my .338-06. Haha! I’m getting somewhere!
Sent from my iPhone using Tapatalk