I got some of this brass from Wes over the summer. I finally got a chance to play with it. I took 20 pieces of brass and took neck wall measurements from 2 spots on each piece. The difference between the 40 measurements was
.0013” which to me is excellent. I then trimmed chamfered and deburred all 20 pieces and weighed them. There was 1.2gr difference between high and low, with only one piece that put it over the 1.0gr mark. I haven’t done a volume test on them, and I don’t think I will. I’m going to use them to work up a 200gr ELD-X load in my rifle.
JTD
Reply With Quote
