So I started a little project, T/C compass with a Boyd’s pro Varmint stock in 6.5 Creedmoor. I got my stock in from Boyd’s and while it looks amazing I had a couple issues, the back action screw hole in the trigger guard was off center(easy fix). When I set the barrel and action in the stock everything lines up perfect, spacing on the barrel is even in both sides. But as I apply torque to the action screws the barre pulls about 1/8” or so left where it is almost touching the stock. I did the paper test on it and it is still free floating but only barely. Question is if I bed the stock do you think it will fix the issue or no?