Giraud tri-way

[Kbeaton]

Finally got time to chuck up my tri-way trimmer. I ran about 100 through it in about 2 minutes. This thing is great! If anyone is on the fence, listen when I say it’s worth every penny. If you process even medium quantities of brass you need one of these.


Sent from my iPhone using Tapatalk

[Wes Sage]

Heck yea!!
They are awesome for sure buddy!!

[CodySPowell]

Finally got time to chuck up my tri-way trimmer. I ran about 100 through it in about 2 minutes. This thing is great! If anyone is on the fence, listen when I say it’s worth every penny. If you process even medium quantities of brass you need one of these.


Sent from my iPhone using Tapatalk

Love mine!!

Sent from my SM-J727V using Tapatalk

[Clopez]

Well I just ordered one for 223. I guess it’s time to get the grinder motor ready too. I can’t wait!!


Sent from my iPhone using Tapatalk

[Solomon.trenton]

Do you have it on a drill press and what do you have hold the case?

Sent from my SM-G930V using Tapatalk

[Kbeaton]

Do you have it on a drill press and what do you have hold the case?

Sent from my SM-G930V using Tapatalk

I chucked mine into a Milwaukee 18V drill. It cuts extremely well just my meat hooks hold the case. It’s very smooth.


Sent from my iPhone using Tapatalk

[Kbeaton]

Just got done doing about 1k cases. This thing is great! Couple problems that came up. These are most likely attributable to my inexperience with this tool.
- I had to stop a few times to clean brass clippings out from the area where it indexes off the cases. This is a bit concerning as some may have slipped by with incorrect cuts.
- there were a few times that if I jammed it in to fast the blades would grab the case and spin it in my fingers
- what’s the best way to empty this thing?
Please chime in if you have any tips.


Sent from my iPhone using Tapatalk

[CodySPowell]

Just got done doing about 1k cases. This thing is great! Couple problems that came up. These are most likely attributable to my inexperience with this tool.
- I had to stop a few times to clean brass clippings out from the area where it indexes off the cases. This is a bit concerning as some may have slipped by with incorrect cuts.
- there were a few times that if I jammed it in to fast the blades would grab the case and spin it in my fingers
- what’s the best way to empty this thing?
Please chime in if you have any tips.


Sent from my iPhone using Tapatalk

I use a Qtip to clean the area where the brass indexes as I trim. I bought some cheap paint brushes to clean the cutter when I'm done.

Sent from my SM-J727V using Tapatalk