I just ordered OEM parts for both the frame and the slide. I am using a SilencerCo threaded barrel, but all other internal parts are OEM. I'm sure I'll do some upgrades later on but to start I wanted to use OEM stuff as a control factor in testing. I'm getting a custom built slide and putting it on a custom frame so there could be differences in theory. This is also my first Glock so I'm not familiar enough with the platform to assume what recoil spring may be best. If I use the factory stuff I figure I'd have a good starting point for any needed upgrades. I grabbed my OEM parts off eBay. They were cheaper there than almost anywhere I searched.
Looking forward to end of December/early January when the slide arrives. All the other pieces are ready for it.

DV8 Raptor One slide in Burnt Bronze cerecote with rmr cut for Burris Fastfire III
Trijicon suppressor height night sights
Burris Fastfire III w/ 8moa dot
Polymer80 OD green textured frame
Zev magwell pro
ETS magazines
As expensive as this custom all American made Glock 19 is it better be awesome, I got a bit carried away with Black Friday hahaha



Sent from my Moto Z (2) using Tapatalk