1/9, 16inOriginally Posted by Guns4545
Sent from my SM-J727V using Tapatalk
1/9, 16in
Sent from my SM-J727V using Tapatalk
There is my 25.0 and 25.2 which was probably better than I printed. I wasn't sighted in for that particular bullet yet. But those were pretty good.
Sent from my SM-G965U1 using Tapatalk
Last edited by Shane P; 11-16-2018 at 06:46 PM.
Cool thanks. My 16" 223 wylde BA Hanson barrel 1:8 twist shoots 25.0gr H335 2.250 decent, but am going to try a bit warmer to see if I can improve a little bit.
Sent from my SM-N910V using Tapatalk
Not bad at all! A little fine tuning and you'll be there!There is my 25.0 and 25.2 which was probably better than I printed. I wasn't sighted in for that particular bullet yet. But those were pretty good.
Sent from my SM-G965U1 using Tapatalk
Sent from my SM-J727V using Tapatalk
No problemo! The Zmax seem to enjoy being pushed a bit. The 25.6 is for LC brass which is what I use for Zmax.
Sent from my SM-J727V using Tapatalk
Yessir in using prepped brass from wes. Thinking about sending him my brass to prep lol. I'm getting lazy. What ya charge me wes per thousand or two.
Sent from my SM-G965U1 using Tapatalk
If you want to process bulk .223 get a Giraud triway trimmer. I can do 1,000 in a couple of hours. [emoji16]
Sent from my SM-J727V using Tapatalk
I have Wes process my brass. Easier on me. Ready to load. I will at some point get a Giraud trimmer though. [emoji6]
Sent from my SM-N910V using Tapatalk
[emoji106]
Sent from my SM-J727V using Tapatalk
I have a rcbs trim mate station, that I can turn them out quick..223 is just small and hate prepping lol
Sent from my SM-G965U1 using Tapatalk
Posting Permissions
Reply With Quote
