QuickLOAD users

[bob3663]

Does anyone have access to quick load? I have a 300 prc I wanna load for. I have the following:

Seekins 26” barrel.
ADG brass
Wlrm primers
RL26 powder.

200 grain accubonds
200 grain partitions
220 grain eld-x

Thanks.

Bob


Sent from my iPhone using Tapatalk

[Jay Andrew]

Does anyone have access to quick load? I have a 300 prc I wanna load for. I have the following:

Seekins 26” barrel.
ADG brass
Wlrm primers
RL26 powder.

200 grain accubonds
200 grain partitions
220 grain eld-x

Thanks.

Bob


Sent from my iPhone using Tapatalk

Expand

I’m still alive, albeit a little slow in the response. I’m busy, busy, busy. If you comment on the thread and do not see my reply in a few hours please send me an email at jay@theballisticassistant.com.

I appreciate the support and love the questions! I’ll run this load. As a side note, QuickLOAD doesn’t model primers, it only uses the minimum “spark” to ignite the powder.


Sent from my iPhone using Tapatalk

[Jay Andrew]

I’m still alive, albeit a little slow in the response. I’m busy, busy, busy. If you comment on the thread and do not see my reply in a few hours please send me an email at jay@theballisticassistant.com.

I appreciate the support and love the questions! I’ll run this load. As a side note, QuickLOAD doesn’t model primers, it only uses the minimum “spark” to ignite the powder.


Sent from my iPhone using Tapatalk

I need a bit more information before I can run this load. Mainly, your intended Cartridge Overall Length (COAL).

Thanks,

Jay