Nufinish in vibratory tumbler

[Jakebert2001]

Gotta watch out when you do that. They shine so brightly they might blind someone.

That’s what I’m after


Sent from my iPhone using Tapatalk

[Clopez]

The before is on right and the tub on left is after.


Sent from my iPhone using Tapatalk

[EUDE75]

Nice

Sent from my SM-P905V using Tapatalk

[Jakebert2001]

Looks great. I learned the hard way about the red paste.


Sent from my iPhone using Tapatalk

[EUDE75]

I did too.

Looks great. I learned the hard way about the red paste.


Sent from my iPhone using Tapatalk

Sent from my SM-P905V using Tapatalk

[Clopez]

Put these in the Lyman and went hunting. Came back and perfect!!


Sent from my iPhone using Tapatalk

[Jakebert2001]

Those great. Load’m up n gettem dirty again.


Sent from my iPhone using Tapatalk

[SAWMAN]

I use NuFinish also. My "typical" is to viberate about 50-75 pieces of rifle brass at a time.
I get her going and dump in the NuFinish. Five minutes later I put in the brass. It is always mixed brass. Some 45-70 and 444Marlin size,some 300BLK size.
My media is walnut because I get it free. I have a buddy that wet tumbles but I consider that a PITA. --- SAWMAN

[xH8machinex]

I have a squirt bottle with a 50/50 mix of nu-finish and mineral spirits mix. I put in my brass and give a little squirt, about a half ounce every time.

Walnut lizard media, never had a clumping issue

[EUDE75]

I have a squirt bottle with a 50/50 mix of nu-finish and mineral spirits mix. I put in my brass and give a little squirt, about a half ounce every time.

Walnut lizard media, never had a clumping issue

Never thought about premixing it. I bet it mixes into the media faster.

Sent from my XT1650 using Tapatalk