I have access to a large amount of lead splice cases. They were used to splice telephone cables together back in the day. Has anyone smelted this stuff down? It's full of a very thick and very sticky fluid. I'm wondering if this stuff will burn off or if it's going to ruin my batch? I tried to google it with no luck
Sent from my iPhone using Tapatalk
When I melt stuff like that down I use a cutting torch outside. At 2000 degrees you'll burn off all the trash pretty easy. Where respirator if itOriginally Posted by Kbeaton
Sent from my SM-G965U1 using Tapatalk
I don't recommend that at all. You want to keep the temperature below lead's boiling point.
The gunk will typically burn off. I use a propane torch to light the smoke up when I'm smelting. It doesn't smoke nearly as bad when it's on fire.
Sent from my SM-G930V using Tapatalk
Yeah I’m not sure about the torch method. It’s a petroleum product. You think that would smoke off? It cleans up with gasoline when you get it on your hands. I just don’t want to ruin all this lead.
Sent from my iPhone using Tapatalk
My bullets turn out great. Ben doing it for years. Everybody has a technique. That's just my first melt and it's in a strainer so it reaches temp and into the first mold it goes.
Sent from my SM-G965U1 using Tapatalk
Those do look good but did they come from a splice case?My bullets turn out great. Ben doing it for years. Everybody has a technique. That's just my first melt and it's in a strainer so it reaches temp and into the first mold it goes.
Sent from my SM-G965U1 using Tapatalk
Sent from my iPhone using Tapatalk
No sir wheel weight
Sent from my SM-G965U1 using Tapatalk
I use my old 10lb pot to clean my lead first. That way my bottom pour stays nice and clean. Plus the smaller pot seems to work a little easier since you're only doing a little at a time.
Sent from my XT1650 using Tapatalk
Posting Permissions
Reply With Quote