Im following the instructions from HyTec powder coatings. The powder is from Prismatic powder. I knew that some powders won't cost well but i tried them to see if theirs would. It was just a trial. I wanted to use theirs because they have a huge selection of colors.
Sent from my XT1650 using Tapatalk
Excellent how to, thanks for taking the time to share!Originally Posted by Reloader762
That’s why I like forums better than Facebook
Sent from my iPad using Tapatalk Pro
Definitely better. I truly appreciate Wes starting this. Thanks again Wes.
Sent from my SM-P905V using Tapatalk
A recent batch. I had run a batch of blue and decided to add what little red I had left. Came out with a funky purplish color.
Some green from the same mould.
I have a collection of lead with lube. Is removing the lube required. Am I past the point of no return such that I should just shoot them? tx
Naw. If libeled is what you like, rock it out. If you plan on pc’ing, I’d suggest recasting them to make sure all the lube is removed. It’s just my limited opinion though.
Definitely don’t try to pc over the lube if that’s what you are asking.
Yes you'll need to remove the lube. Because you cook the bullets at 400 degrees. It'll make a big mess if you don't and the powdercoat won't stick where the lube was.
Sent from my XT1650 using Tapatalk
Removing lube is easy. Just put bullets in boiling water for about 15Min, all the lube will float, bullets not so much.
Big Eddy
Not big and tall but big and round
Posting Permissions
Reply With Quote