I have some Titegroup, N320, and WST that I am looking to trade.
Preferred trades are Varget, TAC, or H4350. SPP / SRP. I am also looking for 223 / 9mm / 45 ACP brass.
I can meet up in the...
Type: Posts; User: eagle-man
I have some Titegroup, N320, and WST that I am looking to trade.
Preferred trades are Varget, TAC, or H4350. SPP / SRP. I am also looking for 223 / 9mm / 45 ACP brass.
I can meet up in the...
I have some CCI 300 to trade for CCI 400. Send a PM.
I did not. I started measuring the primer pockets, the ones where the primers were loose were .2105" The others measure between .2065 and .2105" I am going to check them all and weed out all of the...
These are once fired brass that have not been reloaded. They came from new factory ammo.
Does anyone have any experience reloading Sig brass in 6.5 Creedmoor? I have about 350 that I picked up. I have sized and tumbled them, and just started to prime the lot. I noticed that some of them...
I often travel for work, sometimes on the road three or four nights a week. I am wondering what others do when they are in a hotel room (specific to guns or reloading).
Usually I will clean guns, or...
After I prep my brass and then tumble, I always have corn cob media pieces in the flash hole of the primer pocket. I normally remove these by hand or run them thru the press again with a decapping...
Go to the automotive section of your favorite store and get a bottle of Nu Finish. It is in a orange bottle. I put in a cap ful each batch and it really brings out the shine.