So I have a bit of 7.62. I know you can resize it but would it work. I have a AR10 in 338 fed.
Thanks.
Sent from my iPhone using Tapatalk
Printable View
So I have a bit of 7.62. I know you can resize it but would it work. I have a AR10 in 338 fed.
Thanks.
Sent from my iPhone using Tapatalk
It should work just fine. Check the dimensions in a load manual of the 308 and 338. If my memory serves me, I believe the only difference is the neckQuote:
Originally Posted by Charles Roberts
Sent from my iPhone using Tapatalk
7.62 Nato brass will be heavier and that translates to higher pressures. So, you will need to reduce your starting loads a few grains and work up.
The good side to this is using less powder to reach comparable velocities.
I have a buddy that shoots a AR/338Federal. I gave him a bunch of LC72 MATCH brass.
He resized it all and did not have any problems except for 2 or 3 split necks after resizeing and before reloading. This,in 200 pieces of brass.
He does use a med - - ->hot load. ---- SAWMAN