Originally Posted by
maudib
I have a question regarding the caliper that I currently use for those that have a little more experience in using that tool. Prior to this, my experience with using a caliper was limited, so I am uncertain as to whether this is within the boundaries of acceptable. First off, the one that I have was included in a bundled kit purchased with press, dies, etc. It is a low end piece of equipment. My limited experience with reloading is primarily handgun caliber and I have recently started with 223 Rem. I have noticed a consistent variation of .003 when the cases are being measured at different points in the jaw (top, midway, bottom). Is this an acceptable variance or should I purchase a replacement? If not, do I then use the smallest measurement of the case as the "correct" length?
Thank you in advance for any insight provided.