Printable View
I recently traded some powder coating for some cast lead 44 bullets. The bullets weigh out at 211 gr. and i dont know if i should use data for 200 gr or 220 gr or shoot somewhere in between. any suggestions would be appreciated. These are just for plinking with 44spl or 44mag. thanks
Load with 220gr data if you have it. Always ok to use heavier bullet data with a lighter bullet
Quote:
Originally Posted by bojo1330
I have some 215 grain LSWC that I have been looking for data to use. I like your response Wes. I will have to look for the 220 data.
The 215gr Data will be great buddy!!
As with all loads, start low and work up for your specific gun :)
I cannot find data in my books for the 215. All of these bullets are just for punching paper. I am guessing somewhere in the 5-7 grains of Unique. I use 7.0 under my 240 lswc.
Sent from my SM-S903VL using Tapatalk
Lighter bullets usually use a bit more powder, so I would say even your 240gr load would work for a starting point.
remember that going too low can be as bad as going over on the powder charge
That is true. Stuck bullet in the barrel is no good.
Sent from my SM-S903VL using Tapatalk
It can actually explode with a light powder charge, worse than an overcharge
The powder gets 'Flash Over" and ignites way too fast, causing a pressure spike.Quote:
Originally Posted by Adam Van Camp
I have never heard that before. Maybe I need to start at 7-8 grains then.
Sent from my SM-S903VL using Tapatalk
I would say 6 would be a safe starting spot in a 44mag
Quote:
Originally Posted by Adam Van Camp
I developed the 7 grains of Unique for the 240 so my wife could shoot it. All of the books that I have said to start at 10 grain. That was way to much for my wife.
Sent from my SM-S903VL using Tapatalk
Try the 7gr load with the lighter bullet then. See what you think :)
Will do
Sent from my SM-S903VL using Tapatalk
I use 9 gr Unique with 240 FP xtremes so I would think the 7 gr would be a good place to start with those as well.