1/9, 16inQuote:
Originally Posted by Guns4545
Sent from my SM-J727V using Tapatalk
Printable View
1/9, 16inQuote:
Originally Posted by Guns4545
Sent from my SM-J727V using Tapatalk
There is my 25.0 and 25.2 which was probably better than I printed. I wasn't sighted in for that particular bullet yet. But those were pretty good. https://uploads.tapatalk-cdn.com/201...5598b3f8fe.jpghttps://uploads.tapatalk-cdn.com/201...8737577379.jpgQuote:
Originally Posted by Guns4545
Sent from my SM-G965U1 using Tapatalk
Cool thanks. My 16" 223 wylde BA Hanson barrel 1:8 twist shoots 25.0gr H335 2.250 decent, but am going to try a bit warmer to see if I can improve a little bit.Quote:
Originally Posted by CodySPowell
Sent from my SM-N910V using Tapatalk
Not bad at all! A little fine tuning and you'll be there!Quote:
Originally Posted by Shane P
Sent from my SM-J727V using Tapatalk
No problemo! The Zmax seem to enjoy being pushed a bit. The 25.6 is for LC brass which is what I use for Zmax.Quote:
Originally Posted by Guns4545
Sent from my SM-J727V using Tapatalk
Yessir in using prepped brass from wes. Thinking about sending him my brass to prep lol. I'm getting lazy. What ya charge me wes per thousand or two.Quote:
Originally Posted by CodySPowell
Sent from my SM-G965U1 using Tapatalk
If you want to process bulk .223 get a Giraud triway trimmer. I can do 1,000 in a couple of hours. [emoji16]Quote:
Originally Posted by Shane P
Sent from my SM-J727V using Tapatalk
I have Wes process my brass. Easier on me. Ready to load. I will at some point get a Giraud trimmer though. [emoji6]Quote:
Originally Posted by CodySPowell
Sent from my SM-N910V using Tapatalk
[emoji106]Quote:
Originally Posted by Guns4545
Sent from my SM-J727V using Tapatalk
I have a rcbs trim mate station, that I can turn them out quick..223 is just small and hate prepping lolQuote:
Originally Posted by CodySPowell
Sent from my SM-G965U1 using Tapatalk