Nufinish in vibratory tumbler

Quote:

---

Originally Posted by ReneeMicelli

Gotta watch out when you do that. They shine so brightly they might blind someone.

---

That’s what I’m after


Sent from my iPhone using Tapatalk

https://uploads.tapatalk-cdn.com/201...fb53bc37af.jpg
The before is on right and the tub on left is after.


Sent from my iPhone using Tapatalk

Nice

Sent from my SM-P905V using Tapatalk

Looks great. I learned the hard way about the red paste.


Sent from my iPhone using Tapatalk

I did too.

Quote:

---

Originally Posted by Jakebert2001

Looks great. I learned the hard way about the red paste.


Sent from my iPhone using Tapatalk

---

Sent from my SM-P905V using Tapatalk

Put these in the Lyman and went hunting. Came back and perfect!!https://uploads.tapatalk-cdn.com/201...e1475b81ec.jpg


Sent from my iPhone using Tapatalk

Those great. Load’m up n gettem dirty again.


Sent from my iPhone using Tapatalk

I use NuFinish also. My "typical" is to viberate about 50-75 pieces of rifle brass at a time.
I get her going and dump in the NuFinish. Five minutes later I put in the brass. It is always mixed brass. Some 45-70 and 444Marlin size,some 300BLK size.
My media is walnut because I get it free. I have a buddy that wet tumbles but I consider that a PITA. --- SAWMAN

I have a squirt bottle with a 50/50 mix of nu-finish and mineral spirits mix. I put in my brass and give a little squirt, about a half ounce every time.

Walnut lizard media, never had a clumping issue

Quote:

---

Originally Posted by xH8machinex

I have a squirt bottle with a 50/50 mix of nu-finish and mineral spirits mix. I put in my brass and give a little squirt, about a half ounce every time.

Walnut lizard media, never had a clumping issue

---

Never thought about premixing it. I bet it mixes into the media faster.

Sent from my XT1650 using Tapatalk