I like crimping but is there any point to it if the casings are not all the exact same length? Even within 5 thousands will it not change the pressures and make them less accurate?
Printable View
I like crimping but is there any point to it if the casings are not all the exact same length? Even within 5 thousands will it not change the pressures and make them less accurate?
My question is why aren't they the same length?
Sent from my XT1650 using Tapatalk
Because I don't trim below the lowest recommended length in the book. Some of them are already a few thousandths below that
Sent from my SM-G955U using Tapatalk
Gotcha. I wouldn't think it would matter if its not much below.
Sent from my XT1650 using Tapatalk
I just checked 25 casings. They are all within 3 thousandths. I suppose that shouldn't matter but wanted someone else's opinion. Thank you for the response!
Sent from my SM-G955U using Tapatalk
I do it to stay consistent. But mainly just my plinking loads that get tossed around a bit
No problem.
Sent from my XT1650 using Tapatalk