RCBS Jr3 Primer Catcher

I have an old RCBS Jr3 press that I'll use for bullet and case sizing along with decapping brass before I clean and tumble. I see RCBS has a catcher tray and there are a few folks who 3D print catchers also. I'm looking for thoughts and opinions on which ones work the best.

Look up loadertools.com Chris makes the best there is.

Sent from my LM-Q710(FGN) using Tapatalk

Quote:

---

Originally Posted by Sublime1

Look up loadertools.com Chris makes the best there is.

---

Yep, I saw his. It requires rotating the ram 180 degrees though. Not a deal breaker it just means priming on the press will be a problem if I decide to later on.

Quote:

---

Originally Posted by Steve Lonie

I have an old RCBS Jr3 press that I'll use for bullet and case sizing along with decapping brass before I clean and tumble. I see RCBS has a catcher tray and there are a few folks who 3D print catchers also. I'm looking for thoughts and opinions on which ones work the best.

---

Chris does a good job, I called rcbs and they sent me a free one. But chris will have an upgraded one

Sent from my SM-G965U1 using Tapatalk