Will the standard RCBS carbide sizer die remove the Glock bulge that I hear about?
Sent from my iPhone using Tapatalk
Printable View
Will the standard RCBS carbide sizer die remove the Glock bulge that I hear about?
Sent from my iPhone using Tapatalk
The only die I know of is the Redding G-RX set. But it's only made for 40 S&W and is needed in addition to a normal sizing die. Anything else wont go all the way to the base.
Sent from my SM-G950U using Tapatalk
The buldge weakens the case. Don't risk it. Toss them and upgrade your barrel imo.Quote:
Originally Posted by Devilbird
Sent from my SM-N910V using Tapatalk
I don’t own a glock. I was just curious because I ordered a bunch of once fired brass. I was just wanting to know if the RCBS sizer die would eliminate the bulge in any cases if the were once fired from a glock.Quote:
Originally Posted by Guns4545
Sent from my iPhone using Tapatalk
From what I've seen the buldge brass is getting rare. You will still see them, but they are not as bad. That being said just toss them to be safe. You don't want a kaboom. Good luck and be safe.Sent from my SM-N910V using TapatalkQuote:
Originally Posted by Devilbird
Ok. Thanks for the info!Quote:
Originally Posted by Guns4545
Sent from my iPhone using Tapatalk
There is a good reason why that brass looks like that. It is one of many reasons that I own,carry,and shoot Glocks,almost exclusively.
It will reload without a problem. --- SAWMAN
Anytime.Sent from my SM-N910V using TapatalkQuote:
Originally Posted by Devilbird
BUT . . . the Wolf or Glockmeister bbls will take care of the bulge if you prefer not to have it.
The mentioned bbls WILL make your brass last longer also. ---- SAWMAN
The carbide G-RX die is worth it's weight in gold if you are loading .40 or 10mm for a match barrel. Otherwise you might look at the Lee die that has a few thousandths ground off the base.