Printable View
Can anyone tell me why my seating die is seating the bullets crooked? And some of them are tearing up the copper coating. Some come out perfect and others not. It's getting annoying lol. I have never had any issues with other brands.
Sent from my SM-G955U using Tapatalk
Make sure you are using the correct seating stem. My RCBS 9mm dies came with a flat stem and a concave stem. Flat point or round nose bullets.
Load as much as possible and shoot as much as possible.
That was the first thing I checked. And it is the correct one. It's odd. I loaded some and went to the range and all was good but then I started noticing that they were a hair crooked.Quote:
Originally Posted by Adam Van Camp
Sent from my SM-G955U using Tapatalk
How much bell/expansion are you putting on the case mouth? I put barely enough to let the bullet start.
Load as much as possible and shoot as much as possible.
That's exactly what I doQuote:
Originally Posted by Adam Van Camp
Sent from my SM-G955U using Tapatalk
Check to see if there is anything in the seating stem to make the bullet seat weird. Past that I have no idea.
Load as much as possible and shoot as much as possible.
Will do thank youSent from my SM-G955U using TapatalkQuote:
Originally Posted by Adam Van Camp
Sounds like the die body might possibly be starting to crimp before the bullet is seated also.
Sent from my SM-G950U using Tapatalk
Good point. I use a Lee Factory Crimp Die so my RCBS never does that part. Be fore buying the LFC die I would crush cases preforming both steps at the same time.
Load as much as possible and shoot as much as possible.Quote:
Originally Posted by Jjerome49
I will check that thank youQuote:
Originally Posted by Jjerome49
Sent from my SM-G955U using Tapatalk